3/4 Inch PVC 45 Degree Elbow Fittings, 20 Pack, Fits 1.05" OD SCH40 Pipe

3/4 Inch PVC 45 Degree Elbow Fittings, 20 Pack, Fits 1.05" OD SCH40 Pipe

• CHECK YOUR PIPE OD FIRST: These 3/4 inch PVC 45 degree elbow fittings match SCH40 pipe with a 1.05 in outside diameter. Socket ID is 26.8 mm. Measure your pipe OD before ordering, since a loose socket will not seal under line pressure.
• MEASURED SOCKET DEPTH, NO GUESSING: Each socket takes about 17 mm (0.67 in) of pipe end, so you can plan cut lengths before cementing. The fitting body measures 32.8 mm across and the socket opening 26.8 mm, so you can size it in hand.
• A 45 DEGREE TURN, NOT A HARD 90: The 45 degree angle eases the flow path with less resistance than a sharp 90, so water moves steadily through irrigation lines, drainage runs and greenhouse frames, and your layout stays on one clean angle.
• SOCKET X SOCKET, GLUE OR DRY FIT: Both ends are plain sockets with no threads to strip. Cement them for a permanent joint, or dry fit first to check your layout up front. The smooth inner wall keeps flow steady and cuts friction loss.
• TWENTY PIECES FOR MULTI POINT RUNS: You get 20 white 3/4 inch PVC 45 degree elbows in one box, enough for repairs, watering lines and multi point routing, so one broken turn does not send you out for a single replacement part.