27061 Skeg Guard Fits for Mercury Mariner 75 to 200 HP Outboard 316 SS

27061 Skeg Guard Fits for Mercury Mariner 75 to 200 HP Outboard 316 SS

• FITS for MERCURY MARINER OUTBOARDS (75-225 HP): Engineered for the HP, year, stroke segments — including 75 to 115 HP 4 stroke (2015+), 135 to 200 HP 2 & 4 stroke (1978-2011), 150 to 175 HP Optimax Pro XS on 4.75 inch Torpedo lower units (1978-2018). Replaces reference 27061 254-27061 35-SS620. Confirm HP, year, stroke and gearcase profile before ordering
• PROTECT A GOOD SKEG OR REPAIR A BROKEN ONE: Armor against rocks, shoals, ramp dragging and submerged debris — or install over a broken skeg with as little as 2-3 inches remaining. A fraction of the cost of welding or a new lower unit
• MARINE-GRADE 316 STAINLESS STEEL: 316 stainless, mirror-polished, with a 3mm reinforced lower wear tab where abrasion is worst. Built to outlast thin guards that crack after a single season
• COMPLETE KIT, 10-MIN DIY INSTALL, NO WELDING: Ships complete with self-locking stainless steel hardware and hex tools. Slide on, tap with a rubber mallet, drill and lock. No welding, no epoxy, no curing
• BEST FOR TRAILERED & FRESHWATER USE: Built-in drain hole stops water pooling and freeze damage. Stainless on aluminum can react in salt water — for saltwater/wet-slip boats keep anodes healthy and rinse with fresh water after each trip.