2 Pack Silicone Chainstay Protectors for Bikes, 8.66 x 2.08 in Adhesive Frame Guard Pads for MTB, Road, Gravel and E-Bikes, Helps Reduce Chain Slap and Paint Wear 

2 Pack Silicone Chainstay Protectors for Bikes, 8.66 x 2.08 in Adhesive Frame Guard Pads for MTB, Road, Gravel and E-Bikes, Helps Reduce Chain Slap and Paint Wear 

• CHAINSTAY PROTECTION – The 2 mm silicone layer creates a buffer between the moving chain and bike frame, helping reduce chain slap, scratches and paint wear during everyday rides and rougher trail use. 
• QUIETER, EASIER-TO-CLEAN RIDES – The raised silicone surface helps soften chain contact and reduce rattling over rough roads and trails, then wipes clean after dusty or muddy rides. 
• MEASURE BEFORE ORDERING – Each irregular pad is about 8.66 x 2.08 in at its longest and widest points and 0.08 in thick (220 x 53 x 2 mm); the narrow section is about 1.42 in (36 mm). Confirm the full outline fits before peeling.
• CHECK THE SURFACE CONTOUR – Apply only to a clean, dry, smooth or gently curved area where every edge can make contact. Avoid sharp bends, welds, cable guides and textured finishes; test-position before removing the backing.
• 2-PACK, APPLY ONCE – Use both pads on separate contact areas or keep one as a spare. Apply from one end, press the center and every edge firmly, and avoid repeated removal, reapplication or direct high-pressure washing at the edges.