1-1/2 Inch PVC 45 Degree Elbow Fittings, 10 Pack, Fits 1.90" OD SCH40

1-1/2 Inch PVC 45 Degree Elbow Fittings, 10 Pack, Fits 1.90" OD SCH40

• CHECK YOUR PIPE OD FIRST: This 1-1/2 inch PVC 45 degree elbow fits standard SCH40 pipe with a 1.90 in outside diameter. The size printed on the pipe is not the number you measure, so put a tape on the cut end before ordering. 10 pack.
• MEASURED SOCKET DEPTH, NO GUESSING: A straight pipe slides up to 1.02 in (2.6 cm) into each socket, so you can see real contact before the cement sets. Test fit a cut end first, mark the depth with a pencil, then glue and hold a full minute.
• SOCKET X SOCKET, GLUE OR DRY FIT: Both ends are plain sockets, so there are no threads to strip. Solvent weld them into a permanent line, or dry fit first and pull the frame apart at the end of the season. No special tools needed.
• A 45 DEGREE TURN, NOT A HARD 90: A 45 degree elbow eases the run around instead of forcing a square corner, which keeps the layout compact inside frames and tight bays. Where a single 90 will not clear, two of these will on the same run.
• TEN PIECES FOR MULTI POINT RUNS: Sized for standard 1-1/2 inch SCH40 pipe, in white PVC with a smooth outer wall. Suits garden irrigation, greenhouse hoops, pool and spa lines, drainage runs and DIY frame builds. 10 fittings per pack.