1 Inch PVC 45 Degree Elbow Fittings, Fits 1.315" OD SCH40 Pipe, 20 Pack

1 Inch PVC 45 Degree Elbow Fittings, Fits 1.315" OD SCH40 Pipe, 20 Pack

• CHECK YOUR PIPE OD FIRST: These 1 inch PVC 45 degree elbows fit SCH40 pipe with a 1.315 inch outside diameter. Measure your pipe OD before ordering, because nominal size is not the outside diameter, and a loose socket will not hold.
• MEASURED SOCKET DEPTH, NO GUESSING: Each socket takes a straight pipe 0.94 inch deep, which is 2.4 cm, so a glued joint gets a long overlap instead of a shallow seat. You can dry fit the whole run before you bond anything to it.
• A 45 DEGREE TURN, NOT A HARD 90: The gentle offset keeps a run smooth when you route pipe around a corner, step, or post. Use it for sloped drain lines, offsets, and frame corners where a 90 degree elbow would fight the path.
• SOCKET X SOCKET, GLUE OR DRY FIT: Both ends are plain sockets with no threads to strip. Dry fit the run first, then bond it with primer and solvent cement and let the joint set, or leave it as a push fit for frames you take apart.
• TWENTY PIECES FOR MULTI POINT RUNS: You get 20 white 1 inch PVC elbows in one box, enough for a full frame, a garden row, or a repair list. Keep a few spares on the shelf so a single missing fitting does not stop the whole job.